tag:blogger.com,1999:blog-5944243199175518096.post177061367064766933..comments2023-10-18T02:07:27.539-07:00Comments on Chen-song's 1/72 Scale Miniature Gaming Blog: Failures and Successes with the 3D PrinterChen-songhttp://www.blogger.com/profile/03544239764140983706noreply@blogger.comBlogger6125tag:blogger.com,1999:blog-5944243199175518096.post-3200126330725115892018-07-23T20:43:03.329-07:002018-07-23T20:43:03.329-07:00This comment has been removed by a blog administrator.Hanifahhttps://www.blogger.com/profile/12886835526646410355noreply@blogger.comtag:blogger.com,1999:blog-5944243199175518096.post-84697403303978841832018-06-24T04:52:30.305-07:002018-06-24T04:52:30.305-07:00Impressive, very impressive!Impressive, very impressive!Philhttps://www.blogger.com/profile/08913029478686087197noreply@blogger.comtag:blogger.com,1999:blog-5944243199175518096.post-60005622428922588412018-05-22T10:09:10.560-07:002018-05-22T10:09:10.560-07:00$130 is much more reasonable than, say a Form 2, b...$130 is much more reasonable than, say a Form 2, but then again, the tinkering vs just pulling out models. Lasgunpackerhttps://www.blogger.com/profile/13529298072677726064noreply@blogger.comtag:blogger.com,1999:blog-5944243199175518096.post-77321552645884941092018-05-21T14:13:46.681-07:002018-05-21T14:13:46.681-07:00Mine was $130 US at the time of the Kickstarter, w...Mine was $130 US at the time of the Kickstarter, which was less than one single order I would make on Shapeways. The retail now is $300 though, and I wouldn't recommend it unless you really want to tinker with it. This goes for any 3D printer - they are hobby kits, not consumer products, at this point. This one, the Sparkmaker, is worse than most for that due to the cheap production.Chen-songhttps://www.blogger.com/profile/03544239764140983706noreply@blogger.comtag:blogger.com,1999:blog-5944243199175518096.post-29040026079671311162018-05-21T11:55:17.996-07:002018-05-21T11:55:17.996-07:00Very cool!
I went and looked at printers again a...Very cool! <br /><br />I went and looked at printers again after reading your last post, and hrm... very expensive. I can buy a lot of stuff from Shapeways for the same price as a printer... but at some point the calculation comes out ahead for the printer!Lasgunpackerhttps://www.blogger.com/profile/13529298072677726064noreply@blogger.comtag:blogger.com,1999:blog-5944243199175518096.post-25465091240183407602018-05-21T02:15:37.950-07:002018-05-21T02:15:37.950-07:00Good stuff!Good stuff!Nick Granthttps://www.blogger.com/profile/15668435293578877174noreply@blogger.com